MODELS
SIG80 / SIG80M / SIG110 / SIG110H / SIG110D
Page 1.
INSTALLATION AND OPERATING INSTRUCTIONS
VENTILATION FAN
READ AND SAVE THESE INSTRUCTIONS
GENERAL SAFETY INFORMATION
1.
Make sure that the electric service supply voltage is AC 120V, 60Hz.
2.
Follow all local electrical and safety codes, as well as the National
Electrical Code (NEC) and the Occupational Safety and Health Act (OSH
Act).
3.
Always disconnect the power source before working on or near the
ventilating fan, motor or junction box.
4.
Protect the power cord from sharp edges, oil, grease, hot surfaces,
chemicals or other objects.
5.
Do not kink the power cord.
6.
Do not install the unit where ducts are configured as shown in Fig. A.
7.
Provide suction parts with proper ventilation.
8.
This unit is UL listed for use over a bathtub or shower when installed
in a GFCI protected branch circuit.
9.
These ventilating fans are intended for residential usage only.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY
TO PERSONS, OBSERVE THE FOLLOWING:
1.
Use this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer.
2.
Before servicing or cleaning the unit, switch the power off at the
service panel and lock the service disconnecting means to prevent the
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent
warning device, such as a tag, to the service panel.
3.
Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire -rated construction.
4.
Sufficient air is needed for proper combustion and exhausting of
gases through the flue (chimney) of fuel burning equipment to
guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American Society
for Heating Refrigeration and Air Conditioning Engineers (ASHRAE)
and local code authorities.
5.
When cutting or drilling into the wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6.
Ducted ventilating fans must always be vented to the outdoors.
7.
If this unit is to be installed over a tub or shower, it must be marked as
appropriate for the application and be connected to a GFCI (Ground
Fault Circuit Interrupter) -protected branch circuit.
8.
Do not use this unit with any other solid - state control device.
Solid-state controls may cause harmonic distortion, which can cause a
motor humming noise.
9.
NEVER place a switch where it can be reached from a tub or shower.
10.
Not to be installed in a ceiling thermally insulated to a value greater
than R40. (This is required for installation in Canada only).
Turning angle too large
Duct shrink
Too many elbows
Elbow near the body
Body
Fig. A
CAUTION
1.
For general ventilating use only. Do not use to exhaust hazardous or
explosive materials and vapors.
2.
Not for use in cooking areas. (Fig. B)
3.
This product must properly connect to the grounding conductor of
the supply circuit.
4.
To reduce the risk of injury to persons, install the fan at least 7 feet
(2.1m) above the floor.
45°
Cooking area
45°
Do not install above or
inside this area
Cooking
Equipment
floor
Fig. B
prevent backdrafting. Follow the heating equipment manufacturer’s
