Delta Platinum Edition 28-263, Instruction Manual, Page: 4 / 17

4
Fig. 5
B
C
A
3. Remove two mounting screws, one of which is shown
at (E) Fig. 2, that are holding motor (F) to the top of stand
(A).
IMPORTANT: DO NOT REMOVE CABLE TIE (G)
THAT IS HOLDING SWITCH CORD (H) TO VERTICAL
MOUNTING BAR (J), UNLESS YOU ARE USING THE
ACCESSORY 28-984 HEIGHT ATTACHMENT ON THE
BAND SAW. THIS CABLE TIE (G), WILL KEEP THE
SWITCH CORD (H) FROM CONTACTING THE MOTOR
PULLEY OR BELT DURING OPERATION
.
ASSEMBLING
MOTOR TO STAND
1. To make the motor assembly easier, turn stand (A)
Fig. 3, on its side with two horizontal bars (B) down as
shown.
2. Position motor (C) Fig. 3, on two horizontal support
bars (B) as shown, and fasten with four 3
/
4
long carriage
bolts, two of which are shown at (D), and four flanged
nuts.
IMPORTANT: MAKE CERTAIN MOTOR SHAFT (E)
IS ON THE SAME SIDE OF THE STAND AS THE
LARGE OPENING IN THE TOP OF THE STAND
BEFORE TIGHTENING CARRIAGE BOLTS (D)
. Further
motor alignment will be necessary after band saw is fas-
tened to stand.
3. Insert power cord plug (G) Fig. 4, through the bottom
hole of the band saw stand.
4. Carefully turn the stand right side up.
Fig. 2
Fig. 3
Fig. 4
G
ASSEMBLING MOTOR PULLEY
Assemble motor pulley (A) Fig. 5, to the motor shaft mak-
ing certain set screw (B) in the motor pulley engages with
key (C) in motor shaft.