1
Connect base bracket (F), bottom poles (D) and base stand (E)
as shown using long bolts (G, J) Nuts (K) and Washers (L).
Do not tighten bolts until rack is fully assembled and tubes are
properly aligned. Fully assemble base before continuing.
3
5
Connect top
poles (B) to center
poles (C), secure
with short bolts (I).
Connect top
connector (A) to top
poles (B) using
long bolts (G).
Use short bolt (I) to
attach basket (N) by
positioning in line with
desired height hole
on the inside of the
center pole (C)
(FIGURE 1)
4
2
Connect center poles (C) to bottom poles (D),
secure with short bolts (I).
Adjust position of arms before
placing bike on stand.
Tighten all bolts, using
the wrench to hold nuts
where needed.
O Rings (M) can be used
to slide over base legs
where needed on uneven
floor surfaces
IMPORTANT / SAFETY
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
© Copyright 2020
After rack is assembled
Arms should be placed at
desired height - two per
bike (front and rear).
Front side of rack features the
longer section of the base foot
Need help?
Please do not return to store.
For immediate response email [email protected]
Always load bikes on the arms of the bottom,
front side of the rack first to maintain stability.
Remove bikes from the top first.
Store e-bikes and other heavy
bikes on lower arms only.
Do not allow children to play or hang from rack.
FIGURE 2
FIGURE 1
