Delta DVP-FEN01, Operation Manual

Page: 14 / 64

D V P - F E N 0 1 E t h e r n e t C o m m u n i c a t i o n C a r d O p e r a t i o n M a n u a l
The combination of DVP-FEN01 with a PLC, and the connection of DVP-FEN01 to a network are introduced.
3.1 Installation
Before users install a communication card in a PLC or remove a communication card from a PLC, they have to
turn off the PLC, and open the cover of the slot, as shown below.
1. Installing a communication card: Put a communication card into the slot, and tighten a screw.
2. Removing a communication card
3. Inspection after installation
Users have to power a PLC, and connect a network cable to the RJ45 port on DVP-FEN01 correctly. If the
Link LED indicator is ON, the PLC and DVP-FEN01 are connected correctly and powered normally. Then,
the users have to open DCISoft. In DCISoft, the users have to select the communication port (the RS-232
port or the Ethernet port) which is connected to the communication card, and related parameters. They
have to click
Search or IP search on the toolbar. After search is complete, the icon representing the
communication card and the name DVP-FEN01 will be displayed in DCISoft. After the users click the icon,
they can set network parameters such as an IP address.
3 - 2