2
3
5. Remove the fan junction box cover. Using wire
nut(not supplied), connect house wires to fan wires
as shown in the wiring diagram on page 1. 14AWG
is the smallest conductor that shall be used for
branch circuit wiring. Reattach fan junction box
cover. Reattach fan junction box cover.
wire nut
(not included)
Product
wires
House
wires
5
6. Install a circular 3 in. duct (not included) and secure
it with duct tape or clamps (neither included).
Mount the Fan Body
1
to the joist or stud using
nails or wood screws (not included) were indicated.
Nail
Joist or w
all stud
Tape
3 inch duct
❶
6
7. Plug the fan connector and fan assembly back into
the Fan Body
1
. Reattach the fan assembly using
the three screws removed in step 4.
7
GRILLE INSTALLATION
1. For the LED light connection, plug in the connector
from the grille into the fan housing as shown. Pinch
the mounting springs on the Grille
2
, and insert
them into the narrow rectangular slots inside the
fan. Push the Grille
2
up toward the ceiling.
Turn on electricity at the breaker box after finishing
installation.
Spring
1
CARE AND MAINTENANCE
See safety information before proceeding. Routine
maintenance should be done at least once a year.
• Never use solvents, thinner or harsh chemicals
when cleaning the fan.
• Do not allow water to enter the motor.
• Do not immerse metal parts in water.
• Do not immerse resin parts in water over 140º
Fahrenheit.
Turn off power source. Review all safety precautions
1. To remove grille
2
, squeeze springs and pull down.
2
1
2. Clean the grille
2
in a sink and dry with a cloth.
2
2
3. Remove dust and dirt from the fan body
1
with a
vacuum cleaner.
1
Vacuum
cleaner
3
4. Dampen cloth with dust detergent and wipe the fan
body
1
. Then wipe dry with a clean cloth.
1
4
5. Replace grille
2
back onto fan body
1
.
2
5
6. Turn on power source to operate fan again.
