2
3
5. Remove the wiring box cover from the Fan Body
1
.
Remove the wiring knockout from the wiring box
cover with a flathead screwdriver (not included)
1
5
6. Remove the three screws that hold the fan motor
assembly in place. Remove the fan motor assembly
from the Fan Body
1
. Unplug fan connector.
1
6
7. Pull the wire through the hole and into the junction
box(not included), secure 120VAC house wiring
from the wall diagram on page4. 14AWG is the
smallest conductor that shall be used for branch
circuit wiring.
Push the wires back through the hole. Reattach the
wiring box cover.
7
8. Install a circular 4 in. duct (not included) and secure
it with duct tape or clamps (neither included). Mount
the Fan Body
1
to the joist or stud using nails (not
included) were indicated.
1
Joist or wall stud
4 in. Duct
Nail
Tape
8
9. Plug the fan assembly back into the Fan Body
1
.
Reattach the fan assembly using the three screws.
Plug fan connector.
1
9
GRILLE INSTALLATION
Insert the LED light connector into the fan body.
Pinch the mounting springs on the Grille
2
, and insert
them into the narrow rectangular slots inside the fan.
Push the Grille
2
up toward the ceiling.
Turn on electricity at the breaker box after finishing
installation.
2
1
FAN / LED LIGHT OPERATION
Operation
1. Fan mode:
Turn the Fan switch to operate ON/OFF
of Fan function.
1
2. Light mode:
Turn the Light switch to operate ON/
OFF of LED lighting function.
2
CARE AND MAINTENANCE
See safety information before proceeding. Routine
maintenance should be done at least once a year.
• Never use solvents, thinner or harsh chemicals
when cleaning the fan.
• Do not allow water to enter the motor.
• Do not immerse metal parts in water.
• Do not immerse resin parts in water over 140º
Fahrenheit.
Turn off power source. Review all safety precautions
1. To remove grille
2
, squeeze springs and pull down.
2
1
2. Wash and clean the grille
2
in a sink and dry with a
cloth.
2
2
3. Remove dust and dirt from the fan body
1
with a
vacuum cleaner.
1
Vacuum
cleaner
3
4. Dampen cloth with dust detergent and wipe the fan
body
1
. Then wipe dry with a clean cloth.
1
4
5. Replace grille
2
back onto fan body
1
.
2
5
6. Turn on power source to operate fan again.
