LOUVRES OPERATION
•
Press the SWING button to start the louvers moving from side
to side. This will improve the distribution of the cooled air in
the room. To stop the louvers press the SWING button again.
•
You can change the air direction (up or down) by manually
adjusting the horizontal louvers.
TIMER OPERATION
•
The Timer can be used to switch the product off after a
selected number of hours.
•
Select the desired operating mode.
•
Press the TIMER button once and the product will switch off
after 1 hour. Press the button again for 2 hours, again for 3
hours etc. The maximum timer setting is 8 hours.
•
To cancel the Timer setting press the TIMER button again
until all the timer indicators are not lit.
TANK REFITTING
•
When refitting the tank ensure that
the pump
is seated above
the latch
and that both pipes
are placed inside the tank
•
If the pump
is in the down position
swing it up and rest it on the hinged
latch
•
The pump will lower into the tank as
you refit the tank.
-9-
8.
Check the household voltage to ensure it matches the
appliance's
rate
specification.
9.
DO NOT cover.
10. Always unplug the product before refilling the water tank.
11. Always unplug the product when not in use. To disconnect
from the power supply, grip the plug and pull from the power
socket. Never pull by the cord.
12. This product is not intended for use in wet or damp locations.
Never locate the product where it may fall into a bathtub or
other water container. DO NOT use in bathrooms or outdoors.
When not in use always store in a dry area.
13. DO NOT run power cord under carpeting, or cover with rugs
or runners. Arrange the cord away from areas where it may be
tripped over.
14. Avoid the use of an extension cable as this may overheat and
cause a fire.
15. DO NOT insert or allow objects to enter any ventilation or
exhaust opening as this may damage the product and could
cause an electrical shock or fire.
16. DO NOT use the product in areas where gasoline, paint, or
other inflammable goods and objects.
17. If the supply cord is damaged it must be replaced by the
Manufacturer or an authorised service centre in order to avoid
a hazard.
SAVE AND READ THESE IMPORTANT SAFETY INSTRUCTIONS
-2-
