19
X-FAN
button
Ɣ
Pressing X-FAN button in COOL or DRY mode, the icon “ ” is displayed and
the indoor fan will continue operation for 10 minutes in order to dry the indoor
unit even though you have turned off the unit. After energization, X-FAN OFF is
defaulted. X-FAN is not available in AUTO, FAN and HEAT mode.
MODE button
Ɣ
By pressing this button, Auto, Cool, Dry, Fan, Heat mode can be selected circularly.
Auto mode is default after power on. Under the Auto mode, the temperature will
not be displayed; Under the Heat mode, the initial value is 28
ć
(82
̧
);Under
other modes, the initial value is 25
ć
(77
̧
).
AUTO ;
COOL; DRY;
FAN;
HEAT (only for cooling and heating unit)
SWING UP/
DOWN button
Ɣ
Press this button to set up the swing angle, which circularly changes as below:
This is a universal wireless controller. When it receives any of the swing control
commands of
the swing status keeps at
When the guide louver starts to swing up and down, if SWING funtions is
deactivated, the air guide louver will stop and remains at the current position.
LQGLFDWHVWKHJXLGHORXYHUVZLQJVXSDQGGRZQDPRQJWKRHVH¿YHGLUHFWLRQV
FAN button
Ɣ
By pressing this button, Auto, Low, Middle, High speed can be circularly
selected. After power on, Auto fan speed is default. Under the Dry mode, the
unit can only run at the low fan speed.
Low fan
Middle fan
High fan
Note: Under the DRY mode, the fan will be kept running at the low speed even
though the wireless control displays that the fan speed is changed.
CLOCK button
Ɣ
By pressing this button, the clock is allowed to be set,
with blinking, and
then press the +/- button to adjust the clock within 5 seconds. If the CLOCK
button is pressed down constantly for more than 2 seconds, the clock setting
will increase 10 minutes every 0.5 seconds. After that, another press on
the CLOCK button will make the symbol indicate the setting time and blink.
12:00 is the default when the wireless controller is energized with the symbol
indicating the current clock time.
TIMER ON
button
Ɣ
When TIMER ON is activated, “ON” will blink while the symbol will disappear.
Within 5 seconds it is allowed to set the “ON time by pressing the +/- button.
Each press will make the time increase or decrease one minute. Besides, the
time can also be set by pressing the +/- button constantly. that is, in the early
2.5 seconds, the time will increase/decrease quickly per single minute, and in
the late 2.5, the time will increase/decrease per ten minutes. After the desired
time value is set, press
TIMER
ON again to conform the setting within five
seconds. After that, another press on TIMER on will cancel the setting. Prior to
this setting, the clock shall be set to the actual time.