6
A S S E M B LY
1.
Place gasket (A) Fig. 3, on bottom of motor and
blower assembly (B). Align four holes in gasket with
holes in motor and blower assembly and assemble cover
(C) Fig. 3, to gasket and motor and blower assembly with
four hex head screws, flat washers, lockwashers, and
locknuts (D).
3.
Peel the adhesive paper (E) Fig. 5, from the back of
the gasket material (F) and press the gasket material
around the underside of the dust collector cover (C). Cut
off any excess gasket material.
4.
Carefully turn the assembly over. Place gasket (G)
Fig. 6, over two holes in cover (C) and secure upper inlet
elbow (H) to cover with two 3/8-16 x 1-1/4
hex head
screws and flat washers (J), as shown in Fig. 7.
2.
Fig. 4, illustrates the cover (C) assembled to the
underside of motor and blower assembly (B).
Fig. 3
Fig. 4
Fig. 6
Fig. 5
B
A
C
D
C
B
C
F
E
C
H
J
G
J
J
