9
ADJUSTING TABLE
DISCONNECT MACHINE FROM POWER SOURCE.
To tilt the table, loosen the table tilting handle (A) Fig. 15,
move the table to the desired angle, and tighten the table
tilting handle. The table tilting handle can be reposition-
ed by pulling out the handle and repositioning it on the
hex nut located underneath the handle. Positive table
stops are provided at 90° (A) Fig. 17, and 45° (B) Fig. 17.
To adjust the stops, proceed as follows:
1.
Loosen the table locking handle (A) Fig. 15, and lift
the table up to approximately 10 degrees.
2.
Flip out stop bracket (C) Fig. 16, and lower the table
until the adjustable screw (D) contacts stop bracket (C).
3.
Place a square on the table with one end of the
square against the platen.
4.
Turn the adjusting screw (D) Fig. 16 until the table is
at 90° to the platen and adjust the pointer (E) Fig. 15, to
the 0° mark on the angle-of-tilt scale (F) Fig. 15.
5.
The same procedure is followed when adjusting the
table to stop at the 45° position as shown in Fig. 17.
Fig. 15
Fig. 16
Fig. 17
B
A
E
F
D
C
ADJUSTING POSITION OF
SANDING ARM
DISCONNECT MACHINE FROM POWER SOURCE.
The sanding arm can be positioned in the vertical or
horizontal position, or at any desired angle in between as
follows:
1.
Loosen two bolts (A) Fig. 18, move the sanding arm
to the desired position, and tighten the two bolts.
CAUTION: THE SANDING ARM SHOULD NEVER BE
REPOSITIONED WHILE THE MACHINE IS RUNNING.
2. When moving the sanding arm to the horizontal posi-
tion, the arm will contact the stop (B) as shown in Fig. 19.
IMPORTANT:
BEFORE STARTING THE MACHINE
AFTER REPOSITIONING THE SANDING ARM
ALWAYS CHECK THE TRACKING OF THE BELT.
Fig. 18
Fig. 19
A
B
A
B
