6
ASSEMBLING LEGS TO EDGE
SANDER
Carefully assemble the two support legs to the base of
the edge sander as follows:
1. Fasten each support leg (C) Fig. 3, to the base of the
machine (A) with five 3/8-16 x 1" hex head screws, ten
flat flatwashers, five lockwashers and hex nuts, (D) Fig.
3. Assemble flat flatwashers to screws, insert screws
through holes then assemble flatwashers, then
lockwashers, then hex nuts and tighten firmly.
2. Fig. 4, illustrates both legs (C) assembled to the base
of the sander (A).
ASSEMBLING STARTER BOX TO
CABINET (MAGNETIC CONTROL
MODELS ONLY)
Your edge sander is supplied with magnetic starter,
controls, transformer and overload block (LVC), the
starter box is shipped completely wired to the motor and
push button controls. However, the starter box must be
assembled to the base of the machine as follows:
1. Assemble the starter box (A) Fig. 5, to the base of the
sander using two 1/4-20 x 1/2" hex head screws (B) with
star flatwashers, through the rear of the two pre-drilled
holes (D) in the machine base and into the two tapped
holes (C) in the back of starter box.
2. Fig. 6, illustrates the starter box (A) assembled to the
base of the sander.
ASSEMBLY
WARNING: DO NOT OPERATE THIS TOOL UNTIL YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
Fig. 3
Fig. 4
Fig. 5
Fig. 6
A
C
A
C
A
D
D
A
B
C