5
Fig. 5
Fig. 6
Fig. 7
Fig. 8
ASSEMBLING CASTER
ASSEMBLIES TO BASE
Align the holes in caster assembly (A) Fig. 5, with four
holes in support stand (B) located on the underside of
base (C). Place a lockwasher (E) Fig. 5 onto a hex head
screw (D), insert the hex head screw through the caster
(A), and thread into hole in base (B). Repeat this process
for the three remaining holes in the caster and base.
Assemble the three remaining caster assemblies to the
base in the same manner. Fig. 6 shows a caster
assembled to the base.
ASSEMBLING BLOWER AND
MOTOR ASSEMBLY TO BASE
1.
Set motor assembly (A) Fig. 7, on base (B).
2.
Align mounting holes in the motor assembly (A) Fig.
7, with four pre-drilled holes in base (B). Place a
lockwasher (D) Fig. 7, and a flat washer (E) onto hex
head screw (C). Insert the hex head screw through the
hole in the motor assembly, thread the screw into the
hole in the base, and tighten securely. Repeat this
process for the three remaining holes.
3.
Fig. 8, illustrates the motor assembly fastened to the
base.
B
A
D
E
D
C
A
B
C
E
ASSEMBLY
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE
MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
Summary of Contents for 3 H.P. SINGLE-STAGE DUST COLLECTOR 50-852
Page 14: ...14 NOTES...
