6
Fig. 8
RAISING A N D L O W E R I N G T H E MOBILE B A S E
1.
To raise the mobile base (B) Fig. 8, and allow movement to a new location, push foot lever (A)
downward until the foot lever locks into position.
2.
To lower the mobile base (B) Fig. 8, so it is supported by the floor surface, flip foot lever (A) upward.
3.
IMPORTA N T:TO AVOID P E R S O N A L INJURY,
A LW AY S O P E R AT E T H E M A C H I N E WITH T H E
F O O T L E V E R (A) IN T H E RAISED POSITION A S S H O W N IN FIG. 5.
B
A
ASSEMBLING T H E B A N D S AW
The stand is shipped top down inside the shipping container with the motor mounted to the inside top
of the stand. The on/off switch is wired to the end of the power cord.
The motor must be removed from the inside top of the stand and reassembled to the horizontal mount-
ing bars inside the stand as follows:
1.
Remove the stand (A) Fig. 9, from the shipping con-
tainer being careful not to crimp the switch cord which
extends through the top of the stand. NOTE: Set the
s
tand on several blocks of wood to raise the stand off the
floor surface.
2.
Remove panel (B) Fig. 9, from stand (A) by removing
two screws (C) and loosening two screws (D). Remove
panel on opposite side of stand in the same manner.
Fig. 9
D
A
C
B