Delta 28-206, Instruction Manual, Page: 10 / 24

10
Fig. 8
14. Align the holes in the base (A) Fig. 8, with the holes
in the two sides (B).
15. Insert a M8x1.25x16mm hex head flange screw
through the hole in the side of the stand (B) Fig. 8, and
through the hole in the base (A).
16. Thread a M8x1.25 hex flange nut onto the screw.
NOTE: DO NOT COMPLETELY TIGHTEN THE
HARDWARE AT THIS TIME.
17. Repeat this process for the five remaining holes in
the base.
18. Assemble the other side of the base in the same
manner. Attach the two bases together by inserting a
M8x1.25x16mm hex head flange screw through the hole
(C) Fig. 8, in each base, and thread a M8x1.25 hex
flange nut onto the screw.
A
B
19. Turn the stand over so that it is resting on the base.
20. Slide the two hinges (A) Fig. 9 of the door over the
hinge catches (B), on the stand.
21. Close the door until the door latch (C) Fig. 9,
engages with the side (D).
22. Attach the other door in the same manner.
Fig. 9
Fig. 10
23. Thread a M8x1.25 hex nut onto a M8x1.25x100mm
hex head screw approximately 1/4".
24. Thread the M8x1.25x100mm hex head screw (C)
into the hole (A) Fig. 10, in the top of the stand.
25. Place the damping cap (A) Fig. 10A onto the
threaded end of the screw (C).
26. Align the holes (D) Fig. 10, on the hinges that are
attached to the pulley guard, with the two holes (B) in the
top of the stand.
27. Insert a M5x0.8x10mm pan head screw through the
hole (D) Fig. 10, in the hinge, and the hole (B) in the top
of the stand.
28. Place a 5mm flat washer onto the screw.
29. Thread a M5x0.8 hex nut onto the screw and tighten
securely.
30. Repeat this process for the remaining hole in the
hinge and the top of the stand.
31. Make sure the stand is level and tighten all stand
hardware at this time.
C
C
A
B
C
D
A
C
D
B
B
Fig. 10A
A
C