13
Changing the batteries
CAUTION! Pay attention to the following
instructions in order to avoid mechanical
and electrical damage.
Change the batteries as described in “Inserting
the batteries” if the batteries stop working.
Remove the batteries from the article before
inserting the new batteries.
Charging the storage battery
(figure F)
1. Connect the end of the cable (4a) on the USB
charger cable (4) to the storage battery plug
connector (1e) on the quadrocopter (1).
2. Insert the other end of the cable (4b) on
the USB charger cable to a USB port on a
computer that is switched on or to a charger
station with a USB port.
3. The charge control lamp at the end of the cable
(4b) will switch off.
Note:
The charging time is 40 minutes. The
charge control lamp will switch on as soon as the
storage battery is charged.
Removing the storage battery
Pull on the storage battery plug connector (1d) in
order to remove the storage battery (1g) from the
quadrocopter (1).
Suitable flying surroundings
Surroundings for an optimal flight should fulfil the
following criteria:
• Windless, enclosed area.
• People must maintain a safety distance of 1-2m
from the quadrocopter at the start.
• There must not be any devices in the vicinity
such as air-conditioners, fans, etc. that could
create airflow.
• The room should have no obstacles (e.g. no
lamps etc.)
• A minimum room size of approx. 10 x 6 x 3m
(L x W x H) is required.
• There should be 10m of space on all sides to
perform aerobatics such as loop the loops.
Flight preparation
Pay attention to the following before beginning to
fly the quadrocopter:
1. To start always place the quadrocopter (1) on
a level surface.
2. Always move the throttle (2a) and the joystick
slowly, carefully, and gently.
3. Always watch the quadrocopter during the
flight!
Starting to fly and steering the
quadrocopter
Here are a few tips on steering the quadrocopter
before you start to fly:
• Move the throttle (2a) downwards slightly as
soon as the quadrocopter (1) lifts off.
• Move the throttle (2a) upwards slightly if the
quadrocopter (1) dips.
• Tap the joystick (2d) very gently in the desired
direction in order to fly in a curve.
Starting to fly
1. Set the on and off switch (2b) on the remote
control (2) to ON. The control lamp (2e) will
flash.
2. Set the throttle (2a) to the back.
3. Connect the storage battery plug connector
(1d) to the quadrocopter plug connector (1e).
The control lamps (1c) on the quadrocopter (1)
will light up and a signal tone will sound from
the remote control (2).
4. Push the throttle (2a) all the way forward and
then all the way backward.
5. A signal tone will sound from the remote
control (2). The control lamps (1c) on the
quadrocopter’s (1) will light constantly. The
quadrocopter is now ready to fly.
Setting the speed
You can set two flight speeds on the remote
control (2).
Position -
For the first attempts and with little flying
experience.
Po
For experienced pilots. Set the speed selection
switch (2c) to the desired position.
GB
