11
Chapter 3: Installation
3.1 Mounting
This switch can be mounted in a standard 19-inch equipment rack. Prior rack mounting the
switch, pay particular attention to the following factors:
•
Mechanical Loading: Do not place any equipment on top of a rack-mounted unit.
•
Circuit Overloading: Be sure that the supply circuit to the rack assembly is not overloaded.
•
Grounding: Rack-mounted equipment should be properly grounded. Particular attention
should be given to supply connections other than direct connections to the mains.
To rack-mount devices with sliding rail:
1. Install the front mounting bracket to the device using the six M3 screws provided in the rack
mounting kit.
(Figure 3-1: Installing the Front Mounting Bracket)
2. Pull the inner rail out until it is fully extended, and then push the tab forward to release the
inner rail from the middle rail. Remove the inner rail.
NOTE:
Repeat the similar steps to extend another inner rail.
(Figure 3-2: Removing the Inner Rail)
Summary of Contents for AGC764V1
Page 31: ......
