EN
13
12
5/ Troubleshooting
•
The red LED flashes several times
every time a button is pressed.
The battery is low.
Change the battery.
• Remove an association
- Remove the front face of the remote control.
- Press button A.
The red LED flashes.
- Press
1
2
as many times as required
to select the motor (receiver) to
remove.
- Press the
1
2
button.
The shutter starts.
- Press button A to exit.
• Remove all associations
To release the remote control from all association.
- Remove the front face of the remote control.
- Press button A.
The red LED flashes.
- Press the
1
2
and
1
2
buttons at the same time and
hold for 3 seconds.
The shutters start.
- Press button A to exit.
• Your remote control is lost or not functioning
Initial condition:
The lost remote control was only
associated with a single motor
Turn off the power to the motor, wait 10 seconds, then
turn the motor back on.
From a new remote control:
- Press the B button 2 times, until the LED flashes
orange.
- Press
1
2
and
1
2
for 3 seconds until the flashing stops.
The motor (receiver) has not been associated before
- Restart the association process for your new remote
control.
• The green LED does not flash after briefly pressing
button B.
- Several motors are associated with the remote
control. Therefore, you cannot access the setting
modes in this case.
The remote control must only be associated with one
motor for the settings.
