Delta Controls
Page 4 of 12
The back piece can be mounted to an appropriate electrical box, cabinet or wall. The diagram below shows the
base with the wiring opening and mounting holes above, below and on either side of the opening There are also
mounting holes on each corner of the back plate. The mounting holes above and below the wiring opening align
with a standard electrical box. The four mounting holes at each edge of the back plate or the 2 holes on each
side of the opening can be used for mounting directly onto a wall if an electrical box is not used (it is
recommended that plastic screw anchors – size 10-12 1” - be used. Larger steel wall anchors may be visible
under the back plate mounting pads).
If the controller is being mounted with the back plate there are two holes on either side of the back plate at the
top. The back plate also has one large hole designed for hanging the controller.
To reattach the base, insert the hinged side first and then fold the two sections together. Tighten the screws to
fasten the base to the controller.
Do not over tighten the screws on the controller. This may lead to damage to the housing or
screw holes.
