I
NSTALLATION
G
UIDE
DRP-T0B Rev 8.6 Installation Guide
Document Edition 1.3
Document Edition 1.3
Product Description
The DRP-T0B is used to interface to systems that do not
utilize a front-end system to display and configure information
and objects. This controller can be used to view object and
system status, edit and configure objects that are setup in a
menu structure. Different menu structures can be created
relative to password privileges as well as system options such
as Set Time and Date or Reset.
This controller only communicates on LINKnet and has no I/O
other than the onboard temperature sensor. Programming for
equipment is done through GCL+ and programming for the
DRP-T0B is done with MN (Menu) objects. This is done
through the System controller that the DRP-T0B is connected
to.
Important Information
The DRP-T0B is only supported on System level controllers with 16 Mb of flash memory.
The DRP-T0B will only work with firmware version 3.33 Release 2 and higher.
ORCAview OWS and controller firmware must all be of the same version number (i.e. 3.33) to
be compatible. When upgrading any of these products from older versions (i.e. 3.22 or 3.30),
you must upgrade all the remaining products.
Package Contents
Product: DRP-T0B (Rev 8.6)
DRP-T0B (Rev 8.6) Installation Guide
Two pin connector (AMP643817-2) 18 gauge (orange color)
Two pin connector (AMP643820-2) 24 gauge (white color) for RS-485 connection
2 #6 x 1” screws
1 Service Tool cable
Related Documents
Delta Controls Wiring Guidelines
ORCAview Operator Guide
ORCAview Technical Reference Manual
