Page 3
TITAN I
User manual
fig.4
fig.5
Delta Audio 2014/5
1. Installation
Place first the chassis on a clean
and soft surface. Please pay
attention, that the turntable has
been correctly adjusted in
horizontal and vertical level. The
three regulating feet A1-A3 will help
you with this by using a spirit level.
Then tight the disk-nut as shown in
the fig.4.
With the syringe insert the
specified amount of oil within
the bearing and placed the ball.
Unpack and place the platter
carefully on the bearing which is
mounted in the turntable chassis,
fig.4a below. Important notice:
Please behave gently during the
platter placement at the bearing,
because too much pressure will
cause problem at the bearing housing.
Place first the belt on the platter and
then on pulley.
Connect the power supply chassis
to the Delta Audio turntable
chassis with the umbilical cable
which is provided, as shown in the
fig.5 below.
From power's supply output plug
to the input plug on the turntable.
Connect the power cord to the
main wall plug or to the power
distributor.
fig.4a