Using the projector
Digital Projection E-Vision 4000 Series
Light Source
Input
Picture
Alignment Network
Settings
Info
Light Source
Light Mode
Normal
Custom Light
0
Constant Brightness
Off
Menu = Exit
Menu Select ◄ ►
Scroll ▲ ▼
l
Light Mode
l
Normal
will set the power to 100%.
l
Eco
will automatically set the laser power to 80%.
l
Custom Light
Choose a value between 30 and 100, ranging from 30% to 100% laser
power.
l
Constant Brightness
Set to
On
to initially limit the brightness to 75% of maximum light output.
Light output is then increased in 5% stages until the maximum laser power
has been reached.
As the maximum laser power decreases over time, this will maintain the
projectors light output at the preset brightness for longer.
ECO
Input
Picture
Alignment Network
Settings
Info
ECO
Standby Power
ECO
No Signal Power Off
60
Sleep Timer
120
Menu = Exit
Menu Select ◄ ►
Scroll ▲ ▼
l
Standby Power
l
Choose ECO to disable power on by LAN when the projector is in
low power mode.
l
Choose
On By LAN
to allow power on by LAN when the projector is
in low power mode.
l
Choose
On By HDBase-T
to allow power on by HDBase-T when
the projector is in low power mode.
l
No Signal Power Off
Set a duration to wait before switching the light source off when there is no
input signal. The range is from 0 to 180 minutes in 5 minute increments.
l
Sleep Timer
Turns the projector off after a period of time. Set the number of minutes for
the timer. Choose from
0, 10, 20, 30, 60, 90, 120,180, 240, 360, 480
and
600
minutes.
Operating Guide
Rev A December 2021
page 55
Notes
