7
en
Safety device/Maintenance/Troubleshooting
program to be stored. The current settings and
symbol
are displayed.
At the end of the set time the appliance switches off
automatically. To go back to operating without the timer,
press the timer button twice.
The timer symbol disappears from the display.
note:
the time is settable from 0.5 to 24 hours.
change of the temperature scale
The display can show the temperature in both °f and °C.
To select the desired temperature scale,
when the unit is in
off
position
, press and hold the "+" and "eCO" keys for at
least 10 seconds, then release.
The change of scale will be indicated by two short beeps.
Alarms
The appliance has a diagnostic system that makes it possible
to signal malfunctions.
In case of problems, the display will show an alarm message:
(Probe failure)
With this alarm the appliance does not
operate. Contact the De'Longhi Customer
Service.
(high temperature)
When the product’s internal temperature
is too high, the heating power will
progressively and automatically be reduced.
The display shows
intermittently till
the internal temperature is lowered. To
remove the cause of this alarm check that
the unit is not covered or obstructed.
SAFETY DEVIcE
A safety device switches the heater off in the event of
overheating. Please call the De Longhi customer service.
MAInTEnAncE
Always remove the plug from the power outlet and allow the
radiator to cool. Wipe radiator with a soft damp cloth, do not
use detergents and abrasives.
Should the radiator not be in use over a certain length of
time, wind the cord around the cord holder and store it in a
dry place. This appliance has been built to give many years of
trouble free service. In case of malfunction or doubt, do not try
to repair the heater by yourself: this may result in a fire hazard
or electric shock. Call the De'Longhi Customer Service.
TEcHnIcAL cHARAcTERISTIcS
Power supply
See rating plate
Absorbed power
“
TRouBLESHooTInG
PRoBLEM
cAuSE
SoLuTIon
The appliance doesn't work
The display shows: ht
(high temperature)
- be sure it is plugged in and that the
electrical outlet is working.
- Check for any obstruction.
- The temperature may be set too low.
- Probe failure, the display shows: Pf
- The unit is covered or obstructed.
- Plug into the power outlet.
- Remove the obstruction and let the
appliance cool down. If the appliance
doesn't work please contact the
De'Longhi Customer Service.
- Set the temperature to a higher position.
- Contact the De'Longhi Customer Service.
- Check that the unit is not covered or
obstructed. When the product internal
temperature decreases the alarm will
disappear.
