6
WARNINGS
-
Never use this heating appliance in the
immediate vicinity of a bathtub,
shower, or swimming pool.
-
Use the appliance always and only in
the vertical position.
-
Do not use the appliance to dry laundry,
and do not obstruct the air intake and
outlet grilles (danger of overheating).
-
Do not operate the appliance in con-
tact with walls, furniture, curtains, etc.
-
If the power cord is damaged, it must
be replaced by the manufacturer, the
authorized service facility, or a quali-
fied electrician, in order to prevent the
risk of malfunction.
-
Do not cover the appliance while it is
operating, as this could potentially
cause a fire.
-
Do not use this appliance in a room
smaller than 43 square feet (4 m²).
- Heaters should never be used with an
extension cord or outlet strip. Heaters
should be plugged directly into an outlet.
- Before storing the appliance, check it
is completely off and the cable is
unplugged. At this point wrap the cord
around the base. Do not store in a
dusty room. The room temperature
should be between 32-86°F (0-30°C).
Do not load anything above it.
- Heaters draw more current than small
appliances, overheating of the outlet
may occur even if it has not occured
with the use of other appliances.
Additional safety features
1. Overheating protection: a safety device
switches the heater off if it accidentally
overheats (e.g.: air intake and outlet
grilles obstructed, filter clogged). In this
case remove the plug from the power
outlet and leave it unplugged for a few
minutes, eliminate the cause of
overheating, then plug the fan heater
back and turn it on again.
2. Tip over safety switch: a safety tip-
over switch turns the heater off if it
tips over or is positioned in an impro-
per way that could jeopardize safety.
The appliance emits a beep and the
display will show a blinking dot. After
the appliance has been restored in the
vertical position it will take just few
seconds to start on again.
Note: To avoid overheating the appliance,
do not cover it.
TROUBLE-SHOOTING
In case “
PF
” is displayed and a warning
sound is emitted, there is a fault on the
temperature sensor. If the problem persi-
sts contact the Service Center.
If the appliance shuts off unexpectedly:
-
Check that the appliance is receiving
power.
-
Check that the appliance is in the ver-
tical position and on a flat surface, as
the safety tip-over switch may have
been tripped.
-
Check the temperature set and the
timer: the appliance may be off
because the set temperature has
been reached or the time set on the
timer has elapsed.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference
in a residential installation. This equip-
ment generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance with
the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particu-
lar installation. lf this equipment does
cause harmful interference to radio or
television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to
try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
Modifications not approved by the
party responsible for compliance could
void user’s authority to operate the
equipment.
