17
1. Remove the drip tray and the grounds container (A10) (fig.
27);
2. Empty the drip tray and grounds container and wash them;
3. Check the condensate tray (A9) and empty if necessary;
4. Replace the drip tray and grounds container.
11.5 Cleaning the inside of the coffee machine
Danger of electric shock!
Before cleaning internal parts, the machine must be turned off
(see section “6. TURNING THE APPLIANCE OFF”) and unplugged
from the mains power supply. Never immerse the coffee ma-
chine in water.
1. Check regularly (about once a month) that the inside of the
appliance, accessible after removing the drip tray (A12)
(fig. 27), is not dirty. If necessary, remove coffee deposits
with the brush (C5) supplied and a sponge.
2. Remove all the residues with a vacuum cleaner (fig. 30).
11.6 Cleaning the water tank
1. Clean the water tank (A16) regularly (about once a month)
and whenever you replace the water softener filter (C4) (if
provided) with a damp cloth and a little mild washing up
liquid;
2. Remove the filter (if present) and rinse with running water;
3. Replace the filter (if provided), fill the tank with fresh
water and replace the tank;
4. (Models with water softener filter only) Deliver about 3,38
fl.oz/100 ml of hot water to reactivate the filter.
11.7 Cleaning the coffee spouts
1. Clean the coffee spouts (A7) regularly with a sponge or
cloth (fig. 31);
2. Check that the holes in the coffee spouts are not blocked.
If necessary, remove coffee deposits with a toothpick (fig.
31).
11.8 Cleaning the pre-ground coffee funnel
Check regularly (about once a month) that the pre-ground
coffee funnel (A4) is not blocked. If necessary, remove coffee
deposits with the brush (C5) supplied.
11.9 Cleaning the infuser
The infuser (A15) must be cleaned at least once a month.
Important!
The infuser may not be extracted when the machine is on.
1. Make sure the machine is correctly turned off (see section
“6. TURNING THE APPLIANCE OFF”);
2. Remove the water tank (A16-fig. 3);
3. Open the infuser door (A14) (fig. 32) on the right side of
the appliance;
33
PUSH
4. Press the two coloured re-
lease buttons inwards and
at the same time pull the
infuser outwards (fig. 33);
5. Soak the infuser in water for
about 5 minutes, then rinse
under the tap;
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID -
NO DISH WASHER
Clean the infuser without using washing up liquid as it
could be damaged.
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door;
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 34), then push the PUSH symbol fully
in until it clicks into place;
34
Please note!
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 35.
35
8. Once inserted, make sure the two coloured buttons have
snapped out (fig. 36);
36
PUSH
9. Close the infuser door;
10. Put the water tank back.
Infuser
support
