DèLonghi DEGH60BG, Installation And Service Instructions Use And Care Instructions

Page: 12 / 28

12
5. Check the minimum burner setting by quickly rotating the gas control knob from the
^\!_
carry out the “minimum burner setting adjustment” procedure described below.
6. If satisfactory performance cannot be obtained, the installer shall check the installation
and notify the local gas supply authority for a gas supply problem, or if it is an ap-
pliance problem, our Customer Service Centre should be called to obtain the nearest
$X #!
7. Where the appliance data plate cannot be easily read with the appliance in the instal-
led position the duplicate data plate must be attached to adjacent surface and the du-
plicate Natural gas / ULPG conversion label should also be included where a Natural
gas / ULPG conversion has been completed.
INSTALLATION WITH A FLEXIBLE HOSE ASSEMBLY
If this appliance has to be installed with a hose assembly, the installer shall refer to the
% !
`\^ z{{
z<{\
distance of 250 mm.
" The supply connection point shall be accessible with the appliance installed.
|^#}~€zQJ‚JX !
" The thread connection shall be Rp 1/2” (ISO 7-1) male.
IMPORTANT WARNING: After connection the installer must check that the hose is
not kinked, subjected to abrasion or permanently deformed. The installer must check
also that the hose is not near (or in contact) with any hot surfaces e.g. base of metal
hotplate, underbench oven etc.
The hose assembly shall be as short as practicable and comply with relevant
AS/NZS5601 requirements.
IMPORTANT WARNING: The installer shall ensure the hose assembly is restrained
\ !
Figure 9