CLEANING AND MAINTENANCE
Caution: Always disconnect the appliance from
the mains outlet before performing any cleaning
or maintenance operations.
After the appliance has been used, to ensure
maximum hygiene, the accessories should be
rinsed by vacuuming up clean water. This will
clean the accessories and the inside of the hose.
Always empty out the wet-dry tank after use.
After emptying and rinsing the tank, remove the
foam filter, wash it under running water and let it
dry completely before re-positioning. Periodically
check that the float is free to move (Fig. 8).
The filter must be kept dry to prolong its life.
The filtered air finally passes through a high
efficiency filter with the capacity to trap particles
of over 3 microns in size. This filter must be
replaced if dirty.
To replace it remove the grill that presses against
the side levers (Fig. 9).
Replace the filter by positioning correctly in its
housing.
Reposition the grid and press lightly into place.
The filter must be kept clean and replaced
periodically to ensure the correct operation of the
appliance. The filters can be purchased from
authorised Service Centres.
8
fig. 9
PROBLEM
CAUSE
SOLUTION
• The vacuum cleaner does not
start
• The suction power reduces
and the noise increases
• Water is released during wet
vacuuming
• No power
• The maximum level of water
collection has been reached
• Nozzle, hose or telescopic
tube blocked.
• Float blocked and/or no float
filter (
R
).
• Check the power cord, plug
and outlet
• Press the ON/OFF button,
disconnect the power cord
from the mains power supply
and empty the water
collection tank (
E
)
• Check that the nozzles, the
vacuum hose or telescopic tube
are not blocked and remove
any causes of blockage.
• Release the float, clean
and/or dry, as required, the
foam filter
fig. 8
