9
Please note:
- Never use the heater to dry laundry.
- Never place the power cable on top of the heater while it is
hot.
-
We recommend that you not place the heater in a draught,
because strong draughts of air may adversely affect the
equipment’s operational efficiency.
- Only use the heater in an upright position.
- The heater must be positioned at least 50cm from furniture
or other objects.
-
The first time you use the appliance, operate it of at least 15
minutes with the thermostat at maximum to eliminate the
“new” smell. A little smoke due to the protective substances
applied to the heating element before transport may be
given off.
- Do not obstruct the hot air outlet grilles or the air intake
grille on the bottom of the appliance.
- Position the appliance so that the plug and the outlet can
be easily reached even after installation.
- Do not use the appliance in rooms less than 4 m
2
in area.
- The appliance is fitted with a safety device which will
switch off it in case of accidental overheating. To reset,
please contact Customer Experience, see enclosed
guarantee.
Danger of burns!!
- The use of an extension lead is not recommended, as
overheating of the extension lead may occur during the
operation of the heater.
The appliance complies with the following EC directives:
- Low Voltage Directive 2006/95/EC and subsequent
amendments;
- EEC Directive 2004/108 on electromagnetic compatibility
(EMC) and subsequent amendments;
Disposing of the appliance
In compliance with European directive 2002/96/EC,
the appliance must not be disposed of with household
waste, but taken to an authorised waste separation and
recycling centre.
DESCRIPTION
A
Thermostat
B
Power selector
C/D/E
Power indicator lights
(
MIN, MED, MAX)
F
Cord holder
G
Wheel
USE
Fitting the wheels
Turn the radiator upside down on a rug or soft surface to prevent
damaging the paint finish. Fully unfold the wheels by turning them
outwards (Fig. 1). Turn the radiator back to its upright position.
Caution
Always operate the heater in upright position only (wheels on
the bottom, controls on top).
Any other position could create a hazardous situation.
Location
The heater should not be placed immediately below a power
outlet. Do not use this radiator in rooms with a floor area of less
than 4 m
2
(43 sq. ft. ).
Connection
- Before using the appliance check that your supply voltage
is the same of that shown on the rating label of the unit and
that the power socket and power supply line correspond to
the load specified.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
- This appliance complies with directive 2004/108/ec on
electromagnetic compatibility. Keep loose clothing or
bedding, furniture and flammable material away from the
heater's wall outlet.
Turning on
Insert the plug into an electrical outlet, rotate the thermostat
dial to maximum and turn the unit on as follows using the power
selector:
- Turn the power selector to position MIN to select minimum
output (the min light will be on).
- Turn the power selector to position MED to select medium
output (the min/med lights will be on).
- Turn the power selector to position MAX to select maximum
output (the lights will be on).
Adjusting the thermostat
When the room has reached the desired temperature, turn the
thermostat dial slowly in an anti-clockwise direction until you
hear a "click" and not beyond it. The thermostat will then adjust
Fig. 1
