Page 12
Page 13
WARNING
If uninstalling an existing waste disposer turn
off electrical power at a fuse box or circut
breaker, and make sure disposer is grounded.
Improper connection can result in electric
shock.
Do not position your head or body under
disposer, as the unit coulld fall during removal
or installation
Remove existing disposer
SKIP THIS STEP FOR FIRST TIME INSTALLATION
Turn off electrical power prior to
1.
disconnecting the old disposer.
Unplug the old unit from the power
2.
supply.
If applicable, disassemble the air switch
3.
from the unit by pulling out the air switch
tube.
Disconnect drain trap from disposer waste
4.
discharge pipe with adjustable pliers.
Disconnect dishwasher drain connection
as well, if applicable.
Support the unit with one hand and
5.
insert end of wrench or screwdriver into
right side of one mounting lug on lower
mounting ring. Lift disposer slightly and
loosen lower mounting ring by pushing
or pulling wrench or screwdriver to the
left until disposer is free from mounting
assembly.
NOTE: DISPOSER MAY BE HEAVY
PROVIDE PROPER SUPPORT
Using screwdriver, loosen mounting
6.
screws and pry off snap ring. Remove
old mounting assembly. (Some mounting
assemblies may require additional tools
to remove.)
Push old sink flange up through sink hole
7.
and clean sink flange area of any rust or
other remaining residue.
Disconnect sink drain
FOR NEW INSTALLATION ONLY
Loosen nut at top of drain trap with pipe
1.
wrench.
Loosen nut at top of extension pipe.
2.
Remove extension pipe.
Loosen nut at base of sink flange. If nut is
3.
corroded or too tight, apply lubricant.
Push sink flange up through sink hole
4.
and remove.
Clean sink flange area of any rust or other
5.
remaining residue.
Tools you may need
Phillips and Flathead “Slotted” Screwdrivers
Adjustable Pliers
Hammer
Drain Auger
10 mm (3/8”) Electrical Clamp Connector
Wire Nuts (2)
Pipe Wrench
40 mm (1 ½”) Drain Trap
Water Hose Clamp
Dishwasher Drain Connection Kit
Air Gap
Drain Tube Extension
Hacksaw
Beveled Washer
Installation Dimensions
READ THROUGH THE INSTRUCTIONS IN THIS
MANUAL COMPLETELY AND CAREFULLY BEFORE
INSTALLING THE DISPOSER.
Determine which tools, materials and
accessories you may need before you begin.
Make sure you have all necessary disposer
parts before beginning the installation.
Before You Begin
Before You Begin
Waste Disposer
Sink Baffle
Power cord
Wrench
Mounting ring
Air switch
Air switch tube
Sink Baffle
Stopper
Sink flange
Sink gasket
Backup ring
Slope ring
Snap ring
Screws
Discharge pipe
Flange
Gasket
Bolts x2
360
+13mm when using
a stainless steel sink
All measurements in mm
72
193
150
178
All installation work has to be performed by
Qualified Trades People.
For general enquiries free call De’Longhi:
Australia
1800 126 659
New Zealand
0508 200 300
