OPERATING INSTRUCTIONS
Lighting the heater
1. Turn on the gas at the gas bottle tap.
2. FROM «
G
» POSITION, fully depress the control knob for 10 seconds and turn to
(Small Flame) position. (If pilot flame does not ignite return to starting position and
repeat). When the pilot flame is lit, continue to fully depress the knob for a further 20
seconds to allow the thermocouple probe to heat up. Then turn the knob to select the
desired setting as follows:
(Small Flame) Low Input
(Big Flame) Maximum Input
(Medium Flame) Medium Input,
Auxiliary ignition
Should piezoelectric starter fail to work, repeat operation on control knob and use a match
to light pilot flame and repeat the operations above described.
Tunring off the heater
Turn off the gas bottle tap. The Heater will be totally “OFF” only if the tap at the gas bottle is turned off.
Important
When the large knob is released at the end of the ignition time (see the rating plate and
instruction booklet), it must return upwards by around 5 mm to its initial position. If this does
not happen, close the gas tap and contact your after-sales service centre. Never operate the
appliance with the large knob held downwards by force.
VENTILATED RADIANT HEATER
Electrical connection
- Before using the appliance check that your supply voltage is the same as that shown on
the rating label of the unit.
- Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.
- THIS APPLIANCE CONFORMS TO DIRECTIVE EN 55014 GOVERNING RADIO INTER-
FERENCE.
Operation and use
Fully insert plug into socket-outlet and switch on the fan heater following the instructions of
Fig. 7. Before switching on the gas burner, read carefully the relevant operating instructions.
VENTILATION ONLY
(It can be used together
with the gas burners for
an adequate heat distri-
bution).
OFF
VENTI 1000 W
HEATING RIGHT OR LEFT
(It can be used together with the
gas burners - 4200 W - for the fast
heating of the room).
VENTI 2000 W
HEATING
(It can be used together with
the gas burners - 4200 W -
for the very fast heating of
the room).
Fig. 7
5
TENSION
220-230V
9,0A
50Hz
2000W
FREQUENCY
AMPS
MAXIMUM
POWER
