7
DESCRIPTION
(pag. 3)
A
Thermostat
B
Function selector
C
Pedal switch (certain models only)
D
Swivelling base (certain models only)
E
Switches (only in certain models)
USE
Electrical connection
- Before plugging into the mains, make sure the voltage of your
mains supply corresponds to the value V indicated on the ap-
pliance and that the socket and power line are appropriate for
the load required.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/EC ON
ELECTROMAGNETIC COMPATIBILITY.
Installation
The appliance can be used in the portable configuration or, if pro-
vided with a base, it can be wall-mounted.
To mount on the wall, proceed as follows:
- If the appliance is installed in a room with bath or shower, re-
spect the “safety distances” shown in fig. 1 and always install
away from taps, basins, showers, etc.
- Drill the holes in the wall according to the minimum distances in
fig. 2 and the measurements in fig. 3.
Hang the appliance on the wall and block in place with the
third screw at the bottom.
Installation in a bathroom must be performed by a qualified
electrician only in compliance with current legislation. Screws
and anchors are not included.
Functioning and use
MODELS WITH FUNCTION SELECTOR AND THERMOSTAT.
Make sure the appliance is off before plugging into the mains.
1. Plug into the mains.
2. Turn the thermostat dial to maximum.
3.
Summer mode (fan only):
turn the function selector to the
position.
4.
Low power operation:
turn the function selector to position
1
.
5.
Max power operation:
turn the function selector to posi-
tion
2
.
6.
Switching off:
turn the function selector to the “
0
” position.
Setting the thermostat
Position the thermostat on maximum.
When the room has reached the required temperature, turn the
thermostat dial slowly anticlockwise until you hear a click and the
fan goes off.
The thermostat will then keep room temperature at the selected
level automatically.
Frost prevention mode
With the function selector in position 2 and the thermostat dial in
position , the appliance maintains room temperature at about
5°C, preventing freezing with minimal energy consumption.
Models with thermostat only
To switch the appliance on turn the thermostat dial as far as it
will go to maximum position. To set refer to the paragraph “Set-
ting the thermostat”. To turn the appliance off completely, turn
the dial anticlockwise to minimum, then unplug from the mains
socket.
MODELS WITH SWITCH
- Heating at low power: press switch
(the red zone can be
seen on the switch).
- Heating at maximum power: press both switches
;
(the red zone can be seen on the switch).
- Turning off: turn off both switches.
We recommend unplugging the power cord when the appliance
is not in use.
Please note:
the maximum power is only active when the
switch is pressed.
MODELS WITH SWIVELLING BASE (ON/OFF PEDAL
SWITCH)
A number of models have a swivelling base and ON/OFF pedal
switch.
The appliance can be manually oriented to an angle of 30° to the
right or left to direct the air flow in the preferred direction.
To turn the appliance on, set the thermostat dial and function
selector as described above, then press the pedal on the base.
To turn the appliance off, just press the pedal again.
Important:
the appliance will come on only if you press the
pedal.
MAINTENANCE
- Always unplug from the mains socket before cleaning.
- Clean the air intake and outlet grilles regularly.
- Do not use abrasive products or solvents to clean the ap-
pliance.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power
“
