background image

Frost stat function

Press the      button, it is recommended to select maximum power level.
Set the thermostat dial to the “   “ position (fig. 6).
When set in this way, the appliance will switch on automatically only if the room temperature falls below 5°C, to prevent
freezing, at minimum energy consumption.
This function is not guaranteed in the event of power failures, even if lasting just a few seconds.

Models with turbo fan boost  (see fig. 1)

A number of models have a turbo fan boost for even more rapid and uniform heating. To use this function, press the
switch on the fan grill.

Cool air ventilation

To operate the fan only for “cool air” ventilation, ensure that ECC is off and turn the thermostat to the maximum then
press the switch on the fan grill. 

5

*

USING THE TIMER

If you wish to use the timer, position the switch in the
middle position        . 

1= 

Manual (timer override)

Timed operation

0 = 

Heater off

SETTING THE CORRECT TIME

Check the time on your watch. If for example it is 4.00
pm. (16.00), turn the dial in a clockwise direction until
the number 16 is lined up with the triangular pointer .

21

20

19

16

pointer

N.B.: Never turn the dial in an anti-clockwise direction!

The timer is in effect, an electric clock and works only
if the plug is connected to the power supply.
Whenever the plug is disconnected or there is a
power failure, the clock must be re-set.

TO PROGRAM THE TIMER 

1) Set the operating times by pushing out the

notches on the dial corresponding to the period
required (each notch represents 15 mins.)

2) Make sure that the timer indicates the correct

time (see instructions on setting the correct time).

3) Select the desired function as shown in the table

on page 5.

21

20

19

16

operating time

Once programmed in this way, the appliance will
repeat the pre-established program every day, if the
selector is in the      position.

TIMER OVERRIDE

If you wish to override the timer settings, push the
timer switch to position 1 (fig.4)

manual (timer over-

ride).

To return to timed operation push the switch

back to the middle position      (fig.4)

1

0

5713003700  11-06-2002  14:03  Pagina 5

Reviews: