DeLonghi ESAM 2200, Instructions For Use Manual

Page: 16 / 22

14
Cleaning the drip tray
Important!
If the drip tray is not emptied regularly, the water
could overflow from the edge and seep inside or
around the machine.
This could damage the machine, the surface it
rests on or the surrounding area.
The drip tray is fitted with a level indicator (red)
showing the level of water it contains (fig. 18).
Before the indicator protrudes from the cup tray,
the drip tray must be emptied and cleaned.
To remove the drip tray:
1. Remove the drip tray and the grounds con-
tainer (fig. 17);
2. Empty the drip tray and grounds container
and wash them;
3. Replace the drip tray and grounds container.
Cleaning the inside of the machine
Danger of electric shock!
Before cleaning internal parts, the machine must
be turned off (see “Turning off”) and unplugged
from the mains power supply. Never immerse
the coffee maker in water.
1. Check regularly (about once a month) that
the inside of the appliance (accessible after
removing the drip tray) is not dirty.
If necessary, remove coffee deposits with the
brush supplied and a sponge.
2. Remove the residues with a vacuum cleaner
(fig. 19).
Cleaning the water tank
1. Clean the water tank (A12) regularly using
mild soapy water
2. Rinse the water tank thoroughly and fill the
tank with fresh water and put back in the ap-
pliance.
Cleaning the coffee spouts
1. Clean the coffee spouts with a sponge or
cloth (fig. 21).
2. Check the holes in the coffee spout are
not blocked. If necessary, remove cof-
fee deposits with a toothpick (fig. 22).
Cleaning the pre-ground coffee funnel
Check regularly (about once a month ) that the
pre-ground coffee funnel (A6) is not blocked. If
necessary, remove coffee deposits with a brush.
Cleaning the infuser
The infuser (A11) must be cleaned at least once
a month.
Important!
The infuser must not be extracted when the ma-
chine is on.
1. Make sure the machine is correctly turned
off (see Turning off).
2. Open the service door
3. Extract the drip tray and the grounds contai-
ner (fig. 17).
4. Press the two red release buttons inwards
and at the same time pull the infuser ou-
twards (fig. 22).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Do not use washing up liquid to clean the infuser
as it could cause damage.
5. Soak the infuser in water for about 5 minu-
tes, then rinse under the tap.
6. After cleaning, replace the infuser by sliding
it onto the internal support and pin at the
bottom, then push the PUSH symbol fully in
until it clicks into place.
Please note:
If the infuser is difficult to
insert, before insertion,
adapt it to the right size
by pressing
the two levers
shown in the figure.
7. Once inserted, make sure the two