16
1. Make sure the machine has run the shutdown procedure
correctly (see "5. Turning the appliance off");
2. Remove the water tank (fig. 2).
PUSH
25
24
PUSH
3. Open the infuser door (fig. 24) on the right side of the
appliance.
4. Press the two red release buttons inwards and at the same
time pull the infuser outwards (fig. 25);
Important!
RINSE WITH WATER ONLY
NO DETERGENTS - NO DISH WASHER
Do not use detergents to clean the infuser as this could cause
damage.
5. Soak the infuser in water for about 5 minutes, then rinse
under the tap;
27
26
6. Use the brush (C5) to remove any coffee residues left in the
infuser housing, visible through the infuser door.
7. After cleaning, replace the infuser by sliding it onto the
internal support (fig. 26), then push the PUSH symbol fully
in until it clicks into place.
Please note:
If the infuser is difficult to insert, before insertion, adapt it to the
right size by pressing the two levers shown in fig. 27.
8. Once inserted, make sure the two red buttons have
snapped out (fig. 28).
9. Close the infuser door.
10. Put the water tank back.
28
PUSH
11.10 Cleaning the milk container
To keep the frother efficient, clean the milk container as de-
scribed below, every two days:
1. Remove the lid (D2).
2. Remove the milk spout (D3) and intake tube (D4) (fig. 29).
3. Turn the froth adjustment dial (D1) anticlockwise to the
"INSERT" position (fig. 29) and pull off upwards.
29
4. All components and the container are dishwasher safe, plac-
ing them in the top basket. If you do not have a dishwasher,
wash by hand as described in the note at the end of the
section.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 30). If necessary, scrape the
groove with a toothpick.
