3
Thank you for choosing this De’Longhi radiator. To get the
very best out of your new radiator it is advisable to read
these instructions before using it. This will ensure that you
gain optimum results and use the appliance safely.
General instructions
Take the radiator out of its packing box and remove any polstyrene
pieces or any other packaging material that might be lodged inside it.
Make sure that the radiator has not been damaged during transit and that
the mains cable is in working order.Do not operate the radiator if damaged.
Fitting the feet
Remove the feet and the castors from the polystyrene packing.
Fit the castors to the spindles on the feet and push firmly until they click
into position (fig. 1). Pull each castor to check that it is fitted correctly.
In certain models, the castors are already mounted on the feet.
Using the threaded u-bolt and wing nuts, fit the feet to the bottom of the
radiator between the last two elements as shown in figures 2, 3 and 4.
Depending on the type supplied, type A or type B, mount the feet as
shown in figure 5 or 6.
Important
When in use, the radiator should always be kept vertical (wheels at the
bottom, controls at the top).Any other position could be dangerous!
Electrical connection
-
Before plugging the radiator into the mains, check that your supply
voltage is the same as that shown on the rating plate of the appliance.
- If using more than one radiator at a time, it is important to ensure
that the ring main is adequate to cope with the power requirements.
- It is important to ensure that the socket is adequately earthed.
- This radiator complies with EEC Directive 89/336 relating to elec-
tromagnetic compatibility.
Switching on
Plug into the mains socket.Turn the thermostat to maximum. Switch
the radiator on using the switch/switches following the procedures
given in points a) - b).
a) Models with single switch (1 power level):
-button in position «
I
» = Total power on (indicator light on);
-button in position «
O
» = (indicator light off)
b) Models with double switch (3 power levels)
-button in position «
l
» = minimum power (indicator light on);
-button in position «
ll
» = intermediate power (indicator light on);
Electric oil filled radiator
fig. 1
fig. 2
fig. 3
fig. 4
A
fig. 5
