7
Introduction
Instructions for use
Thank you for choosing this coffee machine. To get the
very best out of your new coffee machine it is advisable
to read these instructions before using the appliance.
This is the only way to ensure optimum results and ma-
ximum safety.
The manufacturer is not liable for damage deriving from
the failure to comply with the user instructions.
Please Note:
Keep these instructions carefully. If the appliance should
be transferred to other persons, these instructions must
accompany it.
Check after transport
After the packaging has been removed, check the
integrity of the appliance and the presence of all
accessories.
Do not use the appliance in the presence of obvious
damage. Contact the De’Longhi Customer Services
department, please see enclosed leaflet.
Installing the appliance
Attention!
The following safety measures must be complied with
when installing the appliance:
• The appliance could be damaged by the penetration
of water.
Do not position the appliance near to water taps or
sinks.
• The appliance could be damaged if the water it
contains freezes. Do not install the appliance in a
room where the temperature can fall below freezing
point.
• Position the power supply cable in a way that it
cannot be damaged by sharp edges or by contact
with hot surfaces.
Connecting the appliance
Attention!
Make sure that the electric mains voltage corresponds
with that indicated on the rating plate on the base of the
appliance.
Only connect the appliance to a correctly installed socket
with a minimum rating of 10A and correctly earthed.
In the case of incompatibility between the socket and
the plug on the appliance, have the plug replaced by a
qualified technician.
• The power supply cable on this appliance must
never be replaced by the user as special tools are
needed for this operation. Contact an After-Sales
Centre authorised by the manufacturer if the cable
is damaged or must be replaced, in order to avoid all
risks. Please refer to enclosed guarantee leaflet for
details.
Filling the water tank
1. Open the water tank lid (fig. 1) and then lift the tank
to remove it (fig. 2).
2. Fill the tank with fresh water but do not pass MAX
level (fig. 3). Re-position the tank by pressing it
lightly in a way to open the valve situated on the
base of the tank itself.
3. Alternatively, do not remove the tank, just fill it by
pouring in water from a jug, be careful of splashes
Attention!
Do not operate the appliance without water in the tank
and always fill it when the water is a few centimetres
from the bottom.
Please Note:
it is normal to find water in the
compartment under the tank; dry using a clean sponge.
