10
6. Fill the container with coffee beans (fig. 5).
IMPORTANT:
to prevent malfunction, never fill with ground coffee, freeze dried coffee, caramelized beans
or anything else which could damage the appliance.
5 TURNING ON AND PREHEATING
1. Press the button (fig. 6). The appliance displays:
HEATING UP PLEASE WAIT...
to indicate preheating is underway.
2. Once preheating is completed, the appliance displays
RINSING PLEASE WAIT...
and performs an automatic rinse cycle (a little hot water runs from the spouts and is collected in the drip
tray below).
Tip:
if you want a short coffee (less than 2 oz), to make it hotter, fill the cup with this hot rinsing water
first. Leave it for a few seconds then empty it to preheat the cup.
3. The appliance now displays the ready message:
READY strong TASTE
6 PREPARING COFFEE (USING COFFEE BEANS)
1. The appliance is preset to make coffee with a strong taste. You can also choose coffee with a mild or reg-
ular taste. To choose the required taste, press the button (fig. 7). The selected coffee taste will be dis-
played.
2. Place 1 cup under the spouts to make 1 shot (fig. 8) or 2 cups for 2 shots (fig. 9). For a creamier coffee,
lower the spouts to bring them as close to the cups as possible (fig. 10).
3. Press the button to make one shot espresso (fig. 11), the button for two shots espresso and the
button for a long shot.
To change the quantity of coffee delivered automatically into the cup, follow the instructions in section
7.
(The appliance now grinds the beans and starts brewing the coffee into the cup.
Once the desired quantity has been reached, the appliance automatically stops delivering the coffee and
ejects the grounds into the coffee grounds container).
4. After a few seconds, the ready message is displayed again and you can make another coffee.
5. To turn the appliance off, press the button.
Before going off, the appliance performs an automatic rinse cycle (a little hot water runs out from the
spouts and is collected in the drip tray beneath).
Take care to avoid scalds.
NOTE 1:
If the coffee is delivered a drop at a time or not at all,
turn the grinding coarseness regulator (fig.
12) one click clockwise (see section 8).
Turn one click at a time until the coffee is delivered adequately.
NOTE 2:
If the coffee is delivered too fast and is not creamy enough,
turn the grinding coarseness regulator
(fig. 12) one click counterclockwise (see section 8).
Avoid turning the grinding coarseness regulator excessively otherwise when you select 2 cups, the coffee may
run out in drips. Mill should only be adjusted while running to prevent jamming.
