17
32
5. Make sure there are no milk residues on the hollow and
groove under the dial. If necessary, scrape the groove with
a toothpick (fig. 31);
6. Check that the intake tube and spout are not clogged with
milk residues;
7. Dry all the components with a clean dry cloth;
8. Reassemble all the lid components;
9. Attach the lid back on the milk container.
13.11 Cleaning the hot water nozzle
Each time you prepare milk, clean the connection nozzle (A8)
with a sponge to remove milk residues from the gaskets (fig.
20).
14. DESCALING
Important!
• Before use, read the instructions and the labelling relative to
the descaler product, which are indicated on the pack (includ-
ed with certain models and/or available for purchase from
authorized service centres).
• Use De’Longhi descaler only. Using unsuitable descaler
and/or performing descaling incorrectly may result in
faults not covered by the manufacturer’s guarantee.
Descaler could damage delicate surfaces. If the product is
accidentally spilt, dry immediately.
To descale
Descaler
De’Longhi “EcoDecalk” descaler
Container
Recommended capacity: 2.0
Time
~45min
Descale the appliance when "DESCALING NEEDED" "PRESS OK
TO START (~45min)" appears on the display: To descale the
appliance immediately, press
and follow the op-
erations from point 3.
To descale the appliance later, press
. The
symbol (B7) appears on the display to remind you that the ap-
pliance needs descaling. (The message appears each time you
turn the appliance on).
To access the descaling menu:
1. Pressthe “
” button (C3) to enter the menu;
2. Press "DESCALE" and follow the instructions on the
display;
3. "REMOVE WATER FILTER" (fig. 33): extract the water tank
(A17), remove the water softener filter (D6) (if present)
and empty the tank. Press
;
33
4. "DESCALER (LEVEL A) AND WATER (LEVEL B)". Pour the des-
caler into the tank up to level A (corresponding to a 100ml
pack) marked on the inner surface of the tank (fig. 34),
then add water (one litre) up to level B (fig. 35) and put the
water tank back. Press
;
5. “EMPTY DRIP TRAY” (fig. 21):
6. Remove, empty and replace the drip tray (A15) and
grounds container (A11). Press
;
7. "POSITION 2l CONTAINER" "OK TO START":
Place an empty container with a minimum capacity of 2 litres
under the hot water spout (D6) and coffee spouts (A9);
B
A
A
B
A
B
34
35
