29
REPLACING THE OVEN LIGHTS
WARNING: Ensure the appliance is switched off before replacing the lamp/s to avoid
the possibility of electric shock.
■
Let the oven cavity and the heating elements to cool down.
■
Switch off the electrical supply.
LEFT LAMP
■
Remove the left wire rack and the side catalytic panel by unscrewing the fixing screws
(see chapter “USE AND CARE” at page 14).
■
Press down from the top the protective cover “
A
” (fig. 18) and remove it by rotating on
the lower side.
IMPORTANT:
Never use screwdrivers or other utensils to remove the cover “
A
”.
This could damage the enamel of the oven or the lampholder. Operate only by hands.
■
Replace the halogen lamp “
B
” with a new one suitable for high temperatures having
the following specifications: 220-240V or 230-240V, 50 Hz and same power (check
watt power as stamped in the bulb itself) of the replaced lamp.
IMPORTANT WARNING: Never replace the lamp with bare hands; contamination
from your fingers can cause premature failure. Always use a clean cloth or gloves.
■
Refit the protective cover “
A”
operating in reverse order.
ATTENTION:
The notch in the inner edge of the cover must be oriented toward the
lamp. Assemble the side catalytic panel and the left wire rack.
TOP RIGHT LAMP:
■
Remove the protective cover “
C
” (fig. 18).
■
Replace the halogen lamp “
B
” with a new one suitable
for high temperatures having the following specifica-
tions: 220-240V or 230-240V, 50 Hz and same power
(check watt power as stamped in the bulb itself) of the
replaced lamp.
IMPORTANT WARNING: Never replace the lamp
with bare hands; contamination from your fingers
can cause premature failure. Always use a clean
cloth or gloves.
■
Refit the protective cover “
C
”.
NOTE:
Oven bulb replacement is not covered by your gua-
rantee.
A
B
B
C
1
2
A
A
WRONG
CORRECT
Figure 18
