DeLonghi CKT 350 Instructions For Use Manual Download Page 5

Page: 5 / 7

E L E C T R I C A L R E Q U I R E M E N T S ( U K O N L Y )

Before using this appliance ensure that the voltage indicated on the product
corresponds with the main voltage in your home, if you are in any doubt about your
supply contact your local electricity company.

The flexible mains lead is supplied connected to a
B.S. 1363 fused plug having a fuse of 13 amp
capacity.Should this plug not fit the socket outlets in
your home, it should be cut off and replaced with a
suitable plug, following the procedure outlined
below.

Note:

Such a plug cannot be used for any other

appliance and should therefore be properly
disposed of, (having removed the fuse) and not left
where children might find it and plug it into a supply
socket - with the obvious consequent danger.

N.B.

We recommend the use of good quality plugs

and wall sockets that can be switched off when the
machine is not in use.

IMPORTANT:

the wires in the mains lead fitted to

this appliance are coloured in accordance with
the following code:

As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured green and yellow must
be connected to the terminal in the plug which is
marked with the letter E or by the earth symbol
or coloured green or green and yellow.

The wire which is coloured blue must be
connected to the terminal which is marked with the
letter

or coloured black.

The wire which is coloured brown must be
connected to the terminal which is marked with the
letter

or coloured red.

When wiring the plug, ensure that all strands of
wire are securely retained in each terminal. Do
not forget to tighten the mains lead clamp on the
plug. If your electricity supply point has only two
pin socket outlets, or if you are in doubt, consult a
qualified electrician.
Should the mains lead ever require replacement, it
is essential that this operation be carried out by a
qualified electrician and should only be replaced
with a flexible cord of the same size.
If the plug is a moulded-on type the fuse cover must be
refitted. If the fuse cover is lost, the plug must not be
used until a replacement cover is obtained. The colour
of the correct replacement fuse cover is that of the
coloured insert in the base of the fuse recess or
elsewhere on the plug. Always state this colour when
ordering a replacement fuse cover.
Only 13amp replacement fuses which are ASTA
approved to B.S. 1362 should be fitted.
This appliance conforms to the Norms EN 55014
regarding the suppression of radio interference.