Safety guard
The guard is to prevent risk of fire and no part of it should be permanently removed.
It
does not give full protection for young children or the infirm.
OPERATING INSTRUCTIONS
Lighting the heater
1. Turn on the gas at the gas bottle tap.
2. FROM «
●
» POSITION, fully depress the control knob for 15 seconds and turn to
(Big Flame) position. (If pilot flame does not ignite return to starting position and repeat).
Continue to fully depress the knob for a further 20 seconds to allow the thermocouple
probe to heat up. Leave control knob in position (big flame) for 10 minutes then turn
the knob to select the desired setting as follows:
(Big Flame) Maximum Input, (Medium Flame) Medium Input,
(Small Flame) Low Input
Auxiliary ignition
Should piezoelectric starter fail to work, repeat operation on control knob and use a match
to light pilot flame.
Turning off the heater
Turn off the gas bottle tap.
The Heater will be totally “OFF” only if the tap at the gas bottle is turned off.
VENTILATED CATALYTIC HEATER
Electrical connection
- Before using the appliance check that your supply voltage is the same as that shown on
the rating label of the unit.
- Connect your heater to earth provided socket only, having a capacity of at least 10/16 A.
- THIS PRODUCT IS MANUFACTURED TO COMPLY WITH THE RADIO INTERFERENCE
REQUIREMENTS OF THE COUNCIL DIRECTIVE 89/336/EEC.
OPERATION AND USE
Fully insert plug into socket-outlet and switch on the fan heater following the instructions of Fig. 7.
Before switching on the gas burner, read carefully the relevant operating instructions.
Ventilation only
(It can be used
together with the gas
burners for an adequa-
te heat distribution).
OFF
Venti 1000W
heating right or left
(It can be used together with
the gas burners - 3000 W - for
the fast heating of the room).
Venti 2000
W heating
(It can be used
together with the gas
burners - 3000 W - for
the very fast heating
of the room).
Fig. 7
5
573244 GB 30-01-2001 09:42 Pagina 5
