Safety instructions
• Protect the product against moisture
• Protect the product against direct sunlight
• Do not look directly into the LED diode of the scanner
Beep tones
Three short beeps
Scanner is active
Two short beeps
Scanner reads successful codes
One long beep
Scanner switches off
Reset to factory settings
To reset the unit to factory settings, please scan the code below. The device will
then be set as a USB keyboard.
USB Connection
With the code below you can set the scanner as a USB keyboard.
If the system asks for a serial port (USB Com) please scan the following code and
install the driver manually.
RS232 Connection
To establish an RS232 connection with the scanner, please scan the code below.
Baude Rate
4800
9600
115200
Scan Mode
You can choose between three different modes.
The Trigger Mode, in which the scan is performed exclusively by pressing a
button.
The autosense mode, where the scanner lights up automatically whenever a
barcode is presented.
And the continuous mode, where the scanner is active and lit all the time.
English
Sound settings
The scanner can be set to two different tone settings.
On
Off
Compensating light
Light on
Light off
LED Light settings
LED on
LED off
German language setting
Before the first use, please scan the codes below - step by step, to confirm the
German keyboard.
Removing the cable from the scanner
If you want to disconnect the scanner from the cable, please use the included
ejection tool.
Insert one end into the small hole on the back of the handle above the opening
where you inserted the cable.
