-
-
Note:
Follow the general instructions for installation of the converter. If necessary,
read the manual of your computer, or ask a specialist for help.
Hardware Installation
Connecting IDE/ATA/ATAPI devices:
1
. Make sure that the Jumper is set on MASTER in your device.
2
. Connect the 40 pin connector of the converter to your device.
3
. Connect the 4 pin cable to the converter and the other side to the device.
4
. Connect the power supply to the power socket and the other side to the
device.
5
. Now follow the driver installation.
Connecting 2.5“ IDE devices:
1
. Connect the 2.5“ IDE adapter to your 2.5“ HDD.
2
. Connect the 40 pin connector to the converter.
3
. Connect the 4 pin cable to the connector and the other side to the IDE
adapter.
4
. Connect the power supply to the power socket and the other side to the
converter.
5
. Now follow the driver installation.
Connecting SATAI/II devices:
If you want to use SATA devices make sure your PC possesses an eSATA port. It
does not work via USB.
1
. Connect the SATA connector of the converter to your SATA device.
2
. Connect the power supply to the power socket and the other side to the
converter.
3
. Now follow the driver installation.
Driver Installation
Windows 2000, XP
1
. Switch on your computer.
2
. Plug the USB cable into your USB Port, resp. the SATA cable into your eSATA
Port.
3
. Switch on your converter.
4
. The converter will be recognized and you can start using the device
immediately.
