ENHANCED MODE
1. With meter powered ON, scroll to #6 (JOB DEF) and press SELECT.
2. Using
key scroll to assigned job (1 to 5).
3. Using
key scroll to DONE and press SELECT.
4. To assign job type, press SELECT. Then press
to toggle between
COMMERCIAL and RESIDENTIAL. Scroll to DONE and press SELECT.
5. To assign ID press SELECT. Use
to change ID number. Scroll to
DONE and press SELECT.
6. Assign Material Temp (70°F if unknown, only required on wood).
7. Assign location definitions by highlighting LOC DEF and pressing
SELECT.
a. Using
scroll to rooms to be tested, using
to assign rooms.
b. For each room assigned, press SELECT to change materials for
that room.
c. When done assigning rooms, scroll to DONE and press SELECT.
8. Scroll to DONE and press SELECT.
9. Choose either SCAN MODE or PIN MODE and press SELECT.
10. Take reading as in earlier instructions.
11. Press SELECT to store the reading. The meter will automatically
advance to the next assigned location, as shown in lower left hand corner.
12. Repeat readings until all locations have been stored.
THERMO-HYGROMETER MODE
1. Insert RH/Temp sensor to connector on top of meter.
2. Using
scroll to RH-T MODE.
3. Press SELECT
NOTE: You may take temperature/RH readings in both BASIC and
ENHANCED modes. In ENHANCED mode, you must press SELECT to
hold the reading and then press it again to move to the next location.
IR LINK
1. You must have Microsoft Excel to use the IR Link Software.
2. Install the software and IR Link as per the instruction manual.
3. Place the Navigator with the Infrared eye pointed toward the eye on the IR
Link.
4. Using buttons scroll to #7 (IR Link) and press SELECT.
5. Do not touch until linking is completed.
510INS-0027/QR
01/14
