4
•
1. Ensure that the area is firm, flat (no bumps or mounds of earth) and extremely level, with a grade not exceeding 3° of slope at any point in the
set-up area.
• 2. Make sure that the area you have selected to set-up the pool is completely free of sticks, stones, sharp objects or other foreign debris.
• 3. Select an area that is not directly underneath overhead power lines or trees. Additionally, make sure that the pool set-up area does not contain
underground utility pipes, lines, or cables of any kind.
• 4. If a ground sheet is provided with your pool kit, its use is highly recommended. The ground cloth will help protect the pool liner from damage
due to weed growth, sharp objects, and debris.
• 5. If at all possible, choose an open location on your property that is exposed to direct sunlight. This will help to warm your pool.
• IMPORTANT: DO NOT
start assembly if any pieces are missing. For replacement pieces contact Dellonda.
• The number of persons required for installation: 2 adults at least.
•
Total installation time except the time for site preparation and water filling :
•
30 minutes for size Ф10’×30”/Ф12’×30” dependent on hose.
•
45 minutes for size Ф14’x33” dependent on hose.
Pool Setup
• Step1.
ACCOUNT
FOR
ALL
PARTS
.
• Remove all the parts from the carton(s) and place them on the ground in the location where they are to be assembled.
• Check each part according to “
CONTENTS
” .Make sure all the pieces to be assembled are accounted for.
• Step2.
INSTALL
DRAIN
VALVES
COVER
AND
STOPPER
• Make sure that outer drain plug is inserted into the outer drain cap and drain valve cover is screwed on tightly. Plug the connection holes with the
stoppers. (The out drain plug changes according to different sizes of pool.)
• Step3.
INSTALL
HORIZONTAL
BEAMS
• Step4.
INSTALL T-JOINTS
• 1. Use the connection end of the T-Joint to connect the adjacent horizontal
tubes.
• 2. Insert the Pin into the hole of the connected horizontal tube and T-Joint
firmly.
• 3. Install the vertical leg cap onto the vertical leg.
• 4. Insert the vertical leg into the T-Joint through the belt.
•
TIP
: If you can’t find the hole on the horizontal tube or vertical leg, rotate the
tubes until the pin meets the hole.
Filling The Pool With Water
• WARNING!
DO NOT
leave pool unattended while filling with water.
• WARNING!
If more than 1~2 inches of water collects on any one side before it
starts filling in the centre. The pool is not level enough, and must be corrected!
Pull out the drain plug, release the water completely, disassemble the pool
completely, locate the pool on a plane level surface, repeat set up instruction.
