About the Product
Manufactured using dual rattan weave 7mm half round and 5mm round creating the impression of wicker. UV Treated, fade resistant and
weatherproof design can be used outside all year round. Supplied with polyester covered seat and back cushions. Cushion covers can be removed
and hand washed for easy maintenance. Some simple assembly is required. Disclaimer: Colours may slightly vary due to lighting conditions.
•
SPECIFICATION
• Model no: ............................................................................................
DG74
• Product dimensions (L x W x H): ................................. 164 x 74 x 80.5cm
• Material: ..................................................................... Polyurethane Rattan
Safety Instructions
• Always read these instructions fully before assembling and using your furniture.
• WARNING!
Keep all flame and heat sources away from this furniture.
• DO NOT
use bleach, alkaline or harsh detergents for cleaning. Soap and warm water are recommended.
•
DO
NOT
use a high-pressure washer to clean this product.
• This product has a reasonable level of protection against
UV
degradation, however as with any material it will begin to fade and degrade after
long periods of exposure to the sun.
Contents
Assembly
SUN LOUNGER
LEG
SUN LOUNGER
SEAT
M6 X 20MM
BOLT
M6 WASHER
HEX KEY
Important Information
Please read these instructions carefully. Note the safe operational requirements, warnings & cautions. Use the product correctly and with care
for the purpose for which it is intended. Failure to do so may cause damage and/or personal injury and will invalidate the warranty. Keep these
instructions safe for future use.
1
www.dellonda.co.uk
Refer to
instruction
manual
• In turn offer up each leg (A) onto the base
frame of the sun lounger (B) bolt into the
frame with the three M6 x 20mm bolts (C)
and the three M6 washers (D).
• Tighten down with the Hex Key (E).
• (Retain the hex key (E) to allow you to tighten
these bolts at a later date).
