Dell Z9000, Configuration Manual

Page: 67 / 968

%TSM-6-SFM_DISCOVERY: Found SFM 8
%TSM-6-SFM_DISCOVERY: Found 9 SFMs
%CHMGR-5-CHECKIN: Checkin from line card 5 (type EX1YB, 1 ports)
%TSM-6-PORT_CONFIG: Port link status for LC 5 => portpipe 0: OK portpipe 1: N/A
%CHMGR-5-LINECARDUP: Line card 5 is up
%CHMGR-5-CHECKIN: Checkin from line card 12 (type S12YC12, 12 ports)
%TSM-6-PORT_CONFIG: Port link status for LC 12 => portpipe 0: OK portpipe 1: N/A
%CHMGR-5-LINECARDUP: Line card 12 is up
%IFMGR-5-CSTATE_UP: changed interface Physical state to up: So 12/8
%IFMGR-5-CSTATE_DN: changed interface Physical state to down: So 12/8
To view any changes made, use the
show running-config logging
command in EXEC privilege
mode, as shown in the example for Configure a UNIX Logging Facility Level .
Configuring a UNIX Logging Facility Level
You can save system log messages with a UNIX system logging facility.
To configure a UNIX logging facility level, use the following command.
• Specify one of the following parameters.
CONFIGURATION mode
logging facility [ facility-type ]
–
auth
(for authorization messages)
–
cron
(for system scheduler messages)
–
daemon
(for system daemons)
–
kern
(for kernel messages)
–
local0
(for local use)
–
local1
(for local use)
–
local2
(for local use)
–
local3
(for local use)
–
local4
(for local use)
–
local5
(for local use)
–
local6
(for local use)
–
local7
(for local use)
–
lpr
(for line printer system messages)
–
mail
(for mail system messages)
–
news
(for USENET news messages)
–
sys9
(system use)
–
sys10
(system use)
–
sys11
(system use)
–
sys12
(system use)
–
sys13
(system use)
–
sys14
(system use)
–
syslog
(for syslog messages)
–
user
(for user programs)
Management
67