Dell Networking W-AP270 Series Outdoor Access Point
| Installation Guide
5
Figure 4
W-AP275 Rear View
USB Console Port
The USB Micro-B console port allows you to connect the AP to a terminal or a laptop for direct local
management. Use the included USB console cable to connect the AP. You can download the necessary driver for
USB-UART adapter from
download.dell-pcw.com
under the
Tools & Resources
tab.
Use the following setting to access the terminal:
Ethernet Ports
The W-AP270 Series access point is equipped with two 10/100/1000Base-T (RJ-45) Gigabit Ethernet ports (WAN
and LAN port) for wired network connectivity. The WAN port supports 802.3at Power over Ethernet (PoE),
accepting 48 VDC (nominal) as a standard defined Powered Device (PD) from a Power Sourcing Equipment
(PSE) such as a PoE midspan injector.
These ports have RJ-45 female connectors with the pin-outs shown in
.
Figure 5
Gigabit Ethernet port Pin-Out
Reset Button
The reset button can be used to return the AP to factory default settings. To reset the AP:
Table 3
Console Settings
Baud Rate
Data Bits
Parity
Stop Bits
Flow Control
9600
8
None
1 None
AC Power Interface
LAN Port
WAN Port
Grounding Point
USB Console Port
and Reset button
