Dell Networking W-AP228 Wireless Access Point
| Installation Guide
9
4. Remove the weatherproof cap on the Ethernet port.
5. Insert the RJ45 connector to the Ethernet port.
6. Screw the clamping ring onto the Ethernet port.
7. Screw the sealing nut onto the clamping ring.
Verifying Post-Installation Connectivity
The integrated LEDs on the AP can be used to verify that the AP is receiving power and initializing successfully
(see
). Refer to the
Dell Networking W-Series
ArubaOS Quick Start Guide
for details on
verifying post-installation network connectivity.
Configuring the AP
AP Provisioning/Reprovisioning
Provisioning parameters are unique to each AP. These local AP parameters are initially configured on the
controller which are then pushed out to the AP and stored on the AP itself. Dell recommends that provisioning
settings be configured via the ArubaOS Web UI only. Refer to the
Dell Networking W-Series
ArubaOS User Guide
for details.
AP Configuration
Configuration parameters are network or controller specific and are configured and stored on the controller.
Network configuration settings are pushed out to the AP(s) but remain stored on the controller.
Configuration settings can be configured via the Dell Networking W-Series ArubaOS Web UI or CLI. Refer to
the
Dell Networking W-Series
ArubaOS User Guide
for details.
NOTE: The seal inside the clamping ring is applicable for cables with 5-8.5 mm diameter. In the cable gland kit, another seal is
provided for use with the cables with 7-10 mm diameter.
