Dell Vostro 410, Service Manual

Page: 99 / 121

Removing and Replacing Parts on the Mini Tower Chassis 5-17
+DUG'LVN'ULYH
)LJXUH +DUG'LVN 'ULYH 5HPRYDO
To remove a hard-disk drive, follow these steps:
5HPRYH WKH KDUGGLVN GULYH EUDFNHW VHH )LJXUH
5HPRYH WKH IRXU VFUHZV WKDW DWWDFK WKH KDUGGLVN GULYH WR WKH
KDUGGLVN GULYH EUDFNHW VHH )LJXUH
6OLGH WKH GULYH RXW RI WKH KDUGGLVN GULYH EUDFNHW
When you replace the hard-disk drive bracket, be sure that it is pushed fully
into the system and snapped into position before you close the drive cage door
(See Figure 5-13).
If you are replacing more than one hard-disk drive in the bracket, do not fully
tighten any of the screws that hold the drives in the bracket until all of the
drives have been placed into the bracket. This prevents the bracket from com-
pressing, which could make it difficult to insert additional drives.
When you are ready to replace the front bezel, be sure to fold the drive cage
door handle down to avoid interference with the front bezel.
tab
1.6-inch drive (front)
bracket
screws (4)