Installing the power button board
1. Place the button board on the chassis.
2. Affix the tape that holds the power button board.
3. Affix the system board cable to the chassis.
4. Place the power button board and tighten the single [M2L2(Big head07)] screw.
5. Connect the system board cable to the power button board.
6. Tighten the single (M2.5L8) screw to secure the display hinge to the power button board.
7. Install the:
a)
b)
c)
d)
8. Follow the procedures in
After working inside your computer
Jäähdytyslevyn
Removing the heat sink
1. Follow the procedure in
Before working inside your computer
.
2. Remove the:
a)
b)
c)
d)
3. To remove the heat sink:
a) Loosen the four captive screws that secure the heat sink to the system board [1, 2, 3, 4].
NOTE:
Loosen the screws in the order of the callout numbers [1, 2, 3, 4]. These screws are retention screws and
cannot be fully removed.
b) Remove the heat sink from the system board [5 ].
28
Purkaminen ja kokoaminen
